About the Real Estate Company
Founded in 1982, the company is comprised of a leading nationwide chain of income-producing properties (predominantly offices and shopping malls), infrastructure services and financial services. Known for its use of highly advanced construction technology, the company owns a total leasable area of approximately 10 million ft 2 with approximately 5 million ft2 under construction.
The real estate company owns an iconic high-rise building in the heart of a major city, and wanted to decrease the energy consumption of its HVAC system while improving comfort at the same time. The air handling units (AHU) have a constant flow of outside air to ventilate the building. High energy consumption is required to condition the air in this seaside climate, with hot, humid summers. Improving energy efficiency, particularly during summer days, was a key driver as electricity costs are more than double during these peak demand hours.
This 50-story building has 38 floors of Class A office space on top of 10 floors of shopping and restaurants. Construction was completed in the late ‘90s, with a modern architectural style.
The tower’s perimeter is over 450 feet, with each floor having a little more than 16,000 ft 2 , bringing the building total to over 800,000 ft 2
The project was led by enVerid Systems working together with the head of HVAC systems for the real estate company, whose participation and support were essential for all logistical and technical aspects of the installation.
The real estate company chose to start with a pilot deployment of one HLR module on the 48 th floor, home to their executive offices. Once completed and verified, they would then implement the other thirty-seven office floors.
The kickoff began with a site survey by the enVerid team of the building mechanical layout, an indoor air quality (IAQ) assessment and identification of potential locations for integrating the HLR module into the existing HVAC system.
The outside air is supplied by the building’s four dedicated outside air systems (DOAS 1 ) shown in figure 2. Two DOAS are located on the roof of the building and two units are in the basement. Each unit can supply up to 50,000 CFM of treated outside air. The outside air from the four DOAS is distributed to the building floors through two shafts located in the center of the building.
The mechanical room on each floor receives outside air through openings in the shafts located at each side of the room. There are dampers on the AHU to control the volume of outside air supplied to the floor.
With HLR Technology, less outside air volume is required, thereby reducing the number of outside air shafts required from two to one – a 35% reduction in area (see figure 2). With this change, the second shaft was reassigned to handle the exhaust from the HLR cartridges during the regeneration phase. Dedicated outdoor unit (VSD extension)
Air pollution is a concern for the tower as it’s located by the highway and two of the DOAS are on the ground level, drawing in particulate matter (PM 2.5 ), carbon monoxide, and other hazardous chemicals from the traffic.
Air conditioning for each office floor is supplied by a central AHU, which delivers air to concealed VAV terminal boxes throughout the floor. The AHU on each office floor is rated at 27,000 CFM (the flow varies according to frequency control), regularly operating from 7:00 AM to 9:00 PM. It is supplied with chilled water and, without HLR Technology, has a constant outside air flow representing about 20% of the total supply air.
Before shipping the HLR modules, the enVerid project team completed their assessment of the HVAC mechanical environments, provided a detailed installation plan and obtained the necessary permits. They developed an energy metering and monitoring plan, and collected and analyzed air samples for baseline indoor air quality. This information was shared with the facilities management team.
During the installation phase the enVerid project team selected and supervised all electrical and mechanical subcontractors with the customer’s approval. Installation was completed without disruption in HVAC operations to building occupants.
An HLR module was installed in the AHU mechanical room (used as an air plenum – mixing return air and outdoor air) on each floor, beginning with the 48th floor (see figure 3).
Installation included wireless Internet connectivity to feed air quality data into the enVerid Cloud for 24/7 monitoring. In addition, HLR modules support BACnet integration into the building management system (BMS). Beginning first with the 48 th floor, then with the other thirty-seven office floors, each HLR module underwent its own acceptance test, and final acceptance tests for the building were completed after all units were tested individually.
Additionally, the enVerid project team continues to work with the company’s Facilities Management team post-installation to optimize energy, IAQ and environmental comfort.
Energy and Air Quality Measurements
Measurements for the 48th floor began on June 30, 2014 and were completed on August 1, 2014. Energy savings and air quality were confirmed, so the project was expanded to all 38 office floors and energy consumption was measured again in summer 2016.
Fifteen electrical meters (for the 11 chillers and 4 DOAS) were installed to monitor the actual electricity consumption. The electrical meters monitor instant energy, daily energy, monthly energy and total cumulative energy consumption. This allows for the most accurate determination of the cooling load and the commensurate energy consumption of the AHU.
Energy metering began prior to HLR module installation to accrue baseline performance of the HVAC system in its current “conventional” operating mode without the HLR modules. Once the HLR modules were installed, the meters were again used to track energy consumption so that a comparison could be done. Additionally, indoor temperature and humidity were monitored to ensure consistency across the measurement period.
For indoor air quality (IAQ), contaminant concentrations were measured prior to the HLR operation, then again after the HLR module had been installed and running for at least one week. IAQ monitoring was performed per US Environmental Protection Agency (EPA) standards and the results were analyzed and certified by an independent lab (PRISM Analytical Technologies).
This investigation included environmental and indoor air quality sampling of temperature, relative humidity, carbon dioxide (CO 2 ), 30 speciated (separated by species) volatile organic compounds (VOC) and total VOC, and formaldehyde. These include all the contaminants of concern found in office buildings. The investigation included sampling at different locations in the building. To prevent instrument-based discrepancies, enVerid calibrated and tracked the instruments used for each type of measurement, along with the manufacturer reported detection principle, resolution, and uncertainty.
557-ton Peak HVAC Load Reduction
The HLR modules reduced peak HVAC load by 24%, or 557 tons on peak days with enthalpy of 41. This has enabled the building to run with fewer chillers in operation, and an upcoming renovation will only replace those chillers necessary, saving significant capital expense.
Reduced Energy Consumption by 1.7 million kWh per Year
Using the HLR modules and their indoor air cleaning capability, the company could take advantage of ASHRAE 62.1 Indoor Air Quality Procedure (IAQP) and use 65% less outside air 2 compared to using the ASHRAE 62.1 Ventilation Rate Procedure (VRP). The total energy saved in one year was calculated to be 1.7 million kWh. Savings were higher in the middle of the day during summer months when electricity tariffs are double.
Energy Consumption Reduced 24% in the Summer, and 20% Annually
When comparing energy consumption for the building with and without the HLR modules, energy savings during the summer was about 24% and roughly 20% annually. Figure 5 shows a sampling of daily measurements of energy consumption during the summer of 2016. The HLR modules were on most days but some days the HLR modules were purposely turned off to compare energy consumption. Figure 6 shows the difference in energy consumption between HLR On and Off, focusing on days when the outdoor enthalpy was similar and the chilled water temperatures were maintained at the same value.
Maintained Excellent Indoor Air Quality
CO 2, Formaldehyde and VOC levels were kept well below target levels specified for excellent indoor air quality (see figures 7, 8 and 9).
enVerid also tested samples of 30 individual speciated (separated by species) VOCs. The results, shown in figure 10 below, demonstrate the air scrubbing effect of the HLR Technology.
Intelligent Indoor Air Quality Management
The HLR deployment was designed to limit CO 2 to 900 ppm and remove VOCs and formaldehyde, and does so on a per-floor basis. If there is a sudden, unexpected increase in occupant density on a floor, like with a special event, the HLR can detect this based on an increase in CO 2 levels. In response, if the HLR cleaning cannot maintain the target CO2 levels, it can increase outside air for just that floor’s AHU to maintain the desired air quality targets. Without the HLR, the existing HVAC system does not have this dynamic outside air ventilation capability. HLR modules also provide anytime, anywhere 24/7 IAQ monitoring using the enVerid Cloud.
- Filters: A 65% reduction in outside air can extend the lifetime of the outside air particulate filters.
- Reduced Water Consumption: Reduced water consumption was not measured specifically but can be a significant savings depending on both water and wastewater rates.
- Reduced Corrosion: A reduction in outside air intake reduces the introduction of saline latent outside air, providing several secondary benefits that include extending the useful life of the existing mechanical equipment and ductwork.
The real estate company is a multibillion-dollar corporation with a large portfolio of a commercial real estate, shopping malls, banking, and energy entities. One of their buildings, located in the heart of a major city, is a skyscraper with a shopping center at its base. Prior to enVerid, the air handling units (AHU) had a constant flow of untreated outside air to ventilate the 50-story building resulting in a high cost of energy consumption to cool (or heat) this outside air.
Faced with higher than desired energy costs and a commitment to high air quality and comfort, the company turned to enVerid for help. Installation of 38 HLR modules was completed on all the office floors without disrupting HVAC operations.
Results: Reduced HVAC capacity, Improved Energy Efficiency and Indoor Air Quality (IAQ)
- 557-ton reduction in HVAC cooling peak load
- 1.7 million kWh annual reduction in energy consumption compared to VRP
- 20% annual / 24% summer reduction in energy
- 65% average reduction in outside air (using ASHRAE IAQP with HLR Technology vs ASHRAE VRP)
- Extended particulate filter life
- Reduced corrosion of equipment and ductwork
- No more occupant complaints – great indoor air quality and comfort
ASHRAE Climate Zone:2a
Deployed: June 2014
Industry: Commercial Real Estate, Shopping Malls, Banking, Energy
Annual Revenue: $2.35 billion (Year Ended December 31, 2015)
Challenges:Reduce HVAC energy expenses across 38 office floors in iconic high-rise building and maintain excellent indoor air quality (IAQ).
Solution:38 enVerid HLR modules – one installed on each office floor – to scrub air of contaminants and reduce the amount of outside air ventilation required. Also, added Variable Speed Drives (VSD) to the AHU outside air intake fans.
- 557-ton reduction in HVAC cooling peak load
- 1.7 million kWh reduction in annual energy consumption compared to VRP
- 20% annual / 24% summer reduction in energy consumption
- 65% average reduction in outside air (using ASHRAE IAQP with HLR modules vs ASHRAE VRP)
- Maintained excellent IAQ
- Improved indoor air quality by reducing VOC and formaldehyde concentrations
- Eliminated complaints about indoor air quality and comfort
- Extended filter life